SKXF Series:

316 STAINLESS STEEL:
SKXF – Shredder Pumps

316 Cast Stainless Steel Pumps with Shredder Action Impellers for Municipal, Industrial and Agricultural Waste-Water

Side discharge and non-clog single vane or double vane impellers for the passing of solids while delivering high volume of liquids.

SKXF Series The Shredder (SKXF) type pumps leave solids slightly larger than if passed through a grinder pump. The shredding action is cause by using a cutting impeller with a Tungsten Carbide Tip, against a "spiral" shaped diffuser plate

All wear and "wet" parts such as impeller, wear-plate, oil housing, pump-housing and inner pump top are made of Cast 316 stainless material. The elastomers such as o-rings, lip seals and gaskets are made of Viton®.

• All parts exposed to pumped liquids are made of 316 Stainless Steel.
• Elastomers are made of Viton®.
• Longer Power Cord – Standard 33ft. power cord.
• Three Seal Motor Protection - Motor is protected by double mechanical seals. Lower seal made of silicon carbide/silicon carbide and upper seal is made of carbon/ceramic. An additional lip seal has been installed above the impeller, to help prevent abrasives such as dirt, silt or sand, from entering into the seal chamber.
• More Motor Protection – Winding protection and (NEMA) Class F motor insulation allows motor temperature to raise to 230°F, superior to pumps with Class A and B insulation. (Specifications dependent on model & may change without notice)

Each pump is tested at factory, both for performance as well as safety. Level controls and level control systems are available.

Viton® is a registered trademark of DuPont Dow Elastomers