JXH Series

316 Cast Stainless Steel HighHead Pumps

Side discharge submersibles are typically used in sump applications where the liquid level can be controlled and where the pumps are partially submerged when in operation. The JXH models are designed for general high head pumping purposes where the passing or shredding of larger solids is not required.

JXH pumps are available in size 2 to 10 HP. Single-phase versions are 2 HP, 230V. Dual mechanical seals with the lower seal made of highly wear resistant Sic/Sic, for less downtime and long life.

All "wet parts" are of highest quality 316 stainless steel. Wear parts are made of Cast material. The 2, 3 and 5 HP JXH pumps are made with Precision Cast Parts (also referred to as Investment Castings), the same quality that is used in aircraft and space vehicles due to it's superior density and strength. Other models are manufactured with sand cast parts. Elastomers such as gaskets and o-rings are made of FKM.

Standard power cable is made of oil resistant quality, which works very well in most environments. EPDM quality cable and elastomers as well as BUNA elastomers are available on special order.

• All metal parts exposed to pumped liquids are made of 316 Stainless Steel.

• Elastomers are made of FKM.

• Longer Power Cord – Standard 33ft. power cord.

• Three Seal Motor Protection - Motor is protected by double mechanical seals. Lower seal made of silicon carbide/silicon carbide and upper seal is made of carbon/ceramic. An additional lip seal has been installed above the impeller, to help prevent abrasives such as dirt, silt or sand, from entering into the seal chamber.

• More Motor Protection – Winding protection and (NEMA) Class F motor insulation allows motor temperature to raise to 230°F, superior to pumps with Class A and B insulation. Automatic switch turns pump motor off if temperature and/or amp draw raises too high. When the motor cools the switch will automatically reset and the pump will turn back on.

• JX55HSS and JX75HSS MODELS - The 7.5 and 10 HP models are designed with an outer sleeve on the impeller shaft. Two oil seal rings, upper and lower, rides on this replaceable shaft which prevents the formation of grooves on the impeller shaft itself.

• TWO PUMPS IN ONE - Most sizes can be converted to a high head version by merely changing the impeller and the suction plate. Other brands often require major changes to achieve different heads or volumes.

• SLIDE RAIL SYSTEMS
  The JX55HSS and JX75HSS models can also be mounted on BJM slide rail systems.

 Each pump is tested at factory, both for performance as well as safety. Level controls and level control systems are available.

(Specifications dependent on model & may change without notice)

 For product brochure, operational manual or dimensions please go to Product Information & Literature